Privateer Leather
Belts
Hardware (buckle and Chicago screws) is available in brass or nickel.
Belts can be made with 5 holes 1" apart, or 7 holes 3/4" apart.
Please note: At this time, I am only able to offer 1.5" belts.
Important: make sure to measure your belt correctly! I cannot accept returns on belts.
Belts are available in the colors shown below.
Sizing instructions
Your belt size is not the same as the waist size on your jeans. If you order your jean waist size, your belt will be too small!
I cannot accept returns on belts, so please make sure you provide an accurate measurement.
The best way to determine your belt size is to measure a belt that you currently use. Lay the belt out flat, and measure from the tip of the buckle tongue to the hole you use most often. Round up to the nearest inch, and that number is your belt size.
In the event that you don't have a belt available to measure from, you can measure your waist with a tailor's measuring tape. Run it through the belt loops in your pants, and round up to the nearest inch.
Even though I wear 36" waist jeans, my waist measures 40-1/4", so I would round up to 41", which is my actual belt size, as verified by measuring from a belt.
Man-O'-War (double-layer w/ reinforcement) - $135
Add border tooling +$40
Add full tooling (basketweave & border) +$85
The Man-O'-War is a stitched double-layer gun belt made from two layers of 7/8-ounce leather. A synthetic stiffener layer is included between the leather layers, and secured at both ends with a decorative stitch pattern. The belt is built pre-curved, which gives the belt a natural shape, prevents wrinkles and puckering, and makes for a more comfortable belt.
The buckle is the highest quality available, made from solid low-lead brass. Hardware (buckle and Chicago screws) are available in brass or nickel finish.
Please note: At this time, I am only able to offer 1.5" belts.
Brigantine (double-layer) - $105
Add border tooling +$40
Add full tooling (basketweave & border) +$85
The Brigantine is a stitched double-layer gun belt made from two layers of 7/8-ounce leather. The belt is built pre-curved, which gives the belt a natural shape, prevents wrinkles and puckering, and makes for a more comfortable belt.
The buckle is the highest quality available, made from solid low-lead brass. Hardware (buckle and Chicago screws) are available in brass or nickel finish.
Please note: At this time, I am only able to offer 1.5" belts.
Merchantman (single-layer) - $75
Add border tooling +$30
Add full tooling (basketweave & border) +$75
The Merchantman is a 1-1/2" single-layer belt made from heavy 11-ounce leather.
This belt is a lower-cost option for those that don't carry a firearm, or for those who carry a small gun inside-the-waistband or in a pocket holster.
The buckle is the highest quality available, made from solid low-lead brass. Hardware (buckle and Chicago screws) are available in brass or nickel finish.
Please note: At this time, I am only able to offer 1.5" belts.